 |
|
|
||
 |
||||
 |
||||
 |
|
|
|
||
|
||||
|
||||
|
| Once you have placed the dial support ring on the movement and the hour wheel on, you are then ready to fit the dial into place. After the dial is on the movement, now install the hands. Turn over the movement and set the dial feet locks in place if you have not done so before. With the dial face down remove the stem (always use a screwdriver to push in the stem release button, since you do not want to push the stem release button down to far), then insert the movement with hands and dial into place. Re-insert the stem, then place the movement case ring into the case. Next screw in the two case screws, place the O-ring gasket in it's groove, then place the tension spring in the back of the case. Screw on the case back and your done with the assembly. |
|
Otto Frei, Watch Parts Since 1930 Customers Entrance 126 2nd St. Oakland, California 94607 Mailing Address: PO BOX 796, Oakland Ca. 94604 Freight Shipment Address: 119 3rd St. Oakland Ca. 94607 USA
|
||||||||
